1992 - Volume #16, Issue #1, Page #33
[ Sample Stories From This Issue | List of All Stories In This Issue | Print this story
| Read this issue]
Angle Finder Level
Our unique new angle finder level is accurate to within plus or minus one-half degree. It's great for any job where you need to set a pitch including laying pipe, roofing, setting concrete, stud work, and even adjusting machinery. You just set the angle on the built-in protractor (no tools needed) and then keep the bubble between the two graduation lines to set the level at the required angle. To measure an angle, you set the level against the incline to be measured and move the protractor until the bubble's in the middle. It's available on levels from 24 in. long ($26.99) up to 72 in. long ($62.99). (Garry Lewis, Excalibur Hand Tools, 10621 So. Lockwood St., Oak Lawn, M. 60453 ph 708 424-4110)
Click here to download page story appeared in.
Click here to read entire issue
To read the rest of this story, download this issue below or click here to register with your account number.
