1997 - Volume #21, Issue #4, Page #33
[ Sample Stories From This Issue | List of All Stories In This Issue | Print this story
| Read this issue]
He Built A Stand To Sharpen Sickles On His IH Mower
 |
 |
"I used an 8-ft. length of 1 in. angle iron. I welded a pair of 3/8-in. hex nuts to it every 24 in. to hold the sickle in place. The angle iron welds across the top of an old wool sack holder that's about 30 in. high. Angled braces support each end of the sickle holder.
"To use, you simply set the sickle in the angle iron and sharpen with a #60 or #80 sanding disk with your sander running on low rpm's."
Click here to download page story appeared in.
Click here to read entire issue
To read the rest of this story, download this issue below or click here to register with your account number.
