"Silage Processor" Conversion Kit For New Holland Pull-Type Forage Harvesters
 ✖  |
"Our new silage processor conversion kit for New Holland 900, 892, and 790 pull-type forage harvesters lets you roll corn kernels while making silage. It lets you quickly convert to making haylage by sliding out the bottom diverter pans. Haylage then bypasses the processor rolls," says Israel Beiler, Georgetown Kernel Processor Co., Christiana, Pa.
The kit consists of two 8 1/2 in. dia. by 22-in. long hardened steel rollers with 1/4-in. machined grooves. The rollers turn at different speeds to provide a shearing action that results in better breakage of kernels. The rollers can be adjusted to vary the crimp spacing. The unit is belt-driven off the tractor pto. To extend the life of the drive belts and bearings, the unit is designed with a stationary top roll, with the bottom roll supported on a through shaft. Stainless steel is used to ex-tend the life of certain high wear parts.
Sells for about $9,000.
Contact: FARM SHOW Followup, Georgetown Kernel Processor Co., Christiana, Pa. 17509 (ph 610 593-2753).
Click here to download page story appeared in.
Click here to read entire issue
"Silage Processor" Conversion Kit For New Holland Pull-Type Forage Harvesters HAY & FORAGE HARVESTING Forage Harvesters 22-5-9 "Our new silage processor conversion kit for New Holland 900, 892, and 790 pull-type forage harvesters lets you roll corn kernels while making silage. It lets you quickly convert to making haylage by sliding out the bottom diverter pans. Haylage then bypasses the processor rolls," says Israel Beiler, Georgetown Kernel Processor Co., Christiana, Pa.
The kit consists of two 8 1/2 in. dia. by 22-in. long hardened steel rollers with 1/4-in. machined grooves. The rollers turn at different speeds to provide a shearing action that results in better breakage of kernels. The rollers can be adjusted to vary the crimp spacing. The unit is belt-driven off the tractor pto. To extend the life of the drive belts and bearings, the unit is designed with a stationary top roll, with the bottom roll supported on a through shaft. Stainless steel is used to ex-tend the life of certain high wear parts.
Sells for about $9,000.
Contact: FARM SHOW Followup, Georgetown Kernel Processor Co., Christiana, Pa. 17509 (ph 610 593-2753).
To read the rest of this story, download this issue below or click
here to register with your account number.
