Home-Built Tow-Behind Roller
 ✖  |
Here's a photo of a tow-behind roller I made using a "pony wheel" off an old tandem roller. I used the original yoke and king pin, welding a 6-ft. drawbar to the kingpin. I used a 2 5/16-in. ball hitch to add flexibility when towing. I put a ratchet jack from the yoke to the drawbar to enable us to offset the roller to reach past the tractor wheel. The roller wheel is 50 in. wide and 40 in. high. (George Wojnar, 5 Malsbury Lane, Cream Ridge, N.J. 08514 ph 609 758-7295)
Click here to download page story appeared in.
Click here to read entire issue
Home-Built Tow-Behind Roller TILLAGE EUIPMENT Miscellaneous 24-4-34 Here's a photo of a tow-behind roller I made using a "pony wheel" off an old tandem roller. I used the original yoke and king pin, welding a 6-ft. drawbar to the kingpin. I used a 2 5/16-in. ball hitch to add flexibility when towing. I put a ratchet jack from the yoke to the drawbar to enable us to offset the roller to reach past the tractor wheel. The roller wheel is 50 in. wide and 40 in. high. (George Wojnar, 5 Malsbury Lane, Cream Ridge, N.J. 08514 ph 609 758-7295)
To read the rest of this story, download this issue below or click
here to register with your account number.
