Self-Starting Generator Runs Only When Needed

Self-Starting Generator Runs Only When Needed ENERGY Miscellaneous 26-4-6 "It starts and stops itself as needed," says Lee Dietsch of Dietsch Mfg., about the company's new Auto Power self-starting generator that runs on demand. The 5,500-watt generator is powered by a 10 hp Briggs & Stratton OHV engine that's fueled by either LP or natural gas, there are two models of the new generator - the Model R and the Model H. To use the Model R, the generator must be hooked to some kind of on-off switch like a float in a water tank, a pressure switch, a thermostat, or a motion detector. When the signal switch goes to the "on" position, the generator starts up, providing 120 to 240-volt power. When the controlling switch goes to the "off" position, the generator shuts down. "It's ideal for pumping water, ventilation, lighting, and other needs in remote locations. You can use it as a primary power source in a remote area, or as emergency backup," says Dietsch. The Model H acts as a standby generator in case of a power failure. It includes a transfer switch (no back feed to power lines) and a built-in battery maintainer. No other switches or controls of any kind are needed. When there's a power loss, the generator starts up and transfers power demand of connected equipment. When normal power is restored, the Auto Power sensor shuts the engine off and switches the power demand back to the utility company. No manual intervention is required. To set it up, you simply plug the devices you wanted protected into outlets on the control box. Then plug the Auto Power into any existing 220-volt outlet. The Model R self-starting generator for remote areas sells for $2,095. The Model H self-starting backup generator sells for $1,995. Contact: FARM SHOW Followup, Lee Dietsch, Dietsch Mfg. LLC, P.O. Box 388, Hamler, Ohio 43524 (ph 419 274-3291).

To read the rest of this story, download this issue below or click here to register with your account number.