Screw-Holding Driver Made In Germany
 ✖  |
Wingfield Distributors, Inc., 4712 N. Cunningham Ave., Urbana, Ill. 61801 ph 800 637-6712; fax 217 643-7849; www.wingfields.com: This company offers a new screw-holding driver made in Germany. The design permits single-handed operation for starting a screw, allowing easier access in tight places. It allows you to place screws through holes or in hard-to-reach places without the screw falling off.
The driver is equipped with a quick release thumb switch that allows fast, easy screw release. You place the screw inside a spring-loaded holder. Once the screw is started, you pull back on the driver shaft and pull the driver down and away, then go back and finish the operation. Two different driver models are available to handle Phillips or slotted-type screws. Call for size application.
Sells for $24 plus S&H.
Click here to download page story appeared in.
Click here to read entire issue
Screw-Holding Driver Made In Germany FARM SHOP Tools 28-6-36 Wingfield Distributors, Inc., 4712 N. Cunningham Ave., Urbana, Ill. 61801 ph 800 637-6712; fax 217 643-7849; www.wingfields.com: This company offers a new screw-holding driver made in Germany. The design permits single-handed operation for starting a screw, allowing easier access in tight places. It allows you to place screws through holes or in hard-to-reach places without the screw falling off.
The driver is equipped with a quick release thumb switch that allows fast, easy screw release. You place the screw inside a spring-loaded holder. Once the screw is started, you pull back on the driver shaft and pull the driver down and away, then go back and finish the operation. Two different driver models are available to handle Phillips or slotted-type screws. Call for size application.
Sells for $24 plus S&H.
To read the rest of this story, download this issue below or click
here to register with your account number.
