Push-Type Cultivator
A one-row cultivator was made from two 12-in. sweeps off an old chisel plow. The sweeps were bolted to a 2 by 2-in., 1/4 in. thick steel tube toolbar that fits into the receiver hitch. H-brackets were fabricated for gauge wheels that mount to the toolbar with U-bolts so they can be adjusted for the desired depth. Activating the winch lifts the cultivator out of the ground for transit on row ends.
Click here to download page story appeared in.
Push-Type Cultivator CULTIVATORS Cultivators (58C) 90-10-77 A one-row cultivator was made from two 12-in. sweeps off an old chisel plow. The sweeps were bolted to a 2 by 2-in., 1/4 in. thick steel tube toolbar that fits into the receiver hitch. H-brackets were fabricated for gauge wheels that mount to the toolbar with U-bolts so they can be adjusted for the desired depth. Activating the winch lifts the cultivator out of the ground for transit on row ends.
To read the rest of this story, download this issue below or click
here to register with your account number.
