2011 - Volume #35, Issue #1, Page #38
[ Sample Stories From This Issue | List of All Stories In This Issue | Print this story
| Read this issue]
Tool Set Restores Farmall Grilles
 |
"They can take the dents out in just a few minutes," says Dick Sunsdahl, Sunsdahl's Restoration Tooling, Faribault, Minn.
Sunsdahl's grille re-forming tools for Deere tractors have been featured before in FARM SHOW (Vol. 29, No. 4). "We've had a lot of requests for Farmall tractors," says Sunsdahl.
His new 3-piece punch and die set is designed to fit the basic grilles produced for Farmall A, B and C models between 1939 and 1954. The tool set restores the horizontal bars of the grilles to original factory shape. The die also acts as a gauge for correct spacing between bars.
Sunsdahl has also introduced a grille re-forming tool set for Farmall M and W-6 tractors; for H and W4 Farmalls; and for 600-650 and W9 models made from 1940-1958. All these tool sets sell for $59 plus $6 S&H.
He has also introduced 5-piece sets to re-form the vertical and horizontal grille bars on Farmall 300-350 and 400-450 models ($100 plus $6 S&H); and he has introduced 2-piece sets for 1955 and newer Farmall Cub models and for 100 û 230 Farmall Cub models made from 1954 to 1958 ($40 plus S&H).
Instructions and tips are included with the purchase of any grille tool set. Additional grille tool sets are also available for Oliver, Ford, Case and Minneapolis Moline tractors.
Contact: FARM SHOW Followup, Sunsdahl's Restoration Tooling, 1703 Greenwood Place, Faribault, Minn. 55021 (ph 507 334-8966; info@sunsdahltooling.com; www.sunsdahltooling.com).
Click here to download page story appeared in.
Click here to read entire issue
To read the rest of this story, download this issue below or click here to register with your account number.
