Setting the Standard for Wear!

Setting the Standard for Wear! TILLAGE EUIPMENT R & H Chrome Alloy ripper points come in several different styles designed for specific uses All of the selections have exceptional wear capabilities but not all of the points perform in the same fashion or were designed for the same purpose Regular ripper points are a good general purpose ripper point that works well in all types of soil conditions The rounded Chrome Alloy plate provides lift to the soil to give a shattering action It was designed in tough northwest soils to be very durable in the adverse conditions Fin ripper points are designed to cut down slabbing problems The point fractures the ground and the fin breaks the slabs allowing the shank to slide through the ground without heaving the soil This cuts down the number of larger clods and slabs of dirt on top of the field This series is especially useful when ripping between rows of plants High Penetration ripper points are designed for more severe conditions where the hardpan won’t allow regular points to penetrate or the soil type requires a more aggressive point High Ridge - High Penetration ripper points are designed for minimum-till and no-till ground conditions Its design allows maximum penetration with less disturbance of the surface soil thus allowing you to rip after the plants have emerged High Ridge Fin ripper points are designed to give the best of two worlds With the high penetration nose it will break through hard pan and the fin will cut down the slabbing and larger clods on the surface of the field 10 Bolt-On Wing ripper points consist of a ripper point complete with brackets and cast Chrome Alloy replaceable wings to fit a wide variety of rippers These versatile winged ripper points give an aggressive stirring of soil to greatly increase shatter and aeration Wing Cap and Wing Cap Fin ripper points measure 6” tip-to-tip The wing runs fairly flat to enhance shatter without lifting and moving large volumes of soil Fin model helps reduce slabbing 6 or 8” Wing Base ripper points are a one-piece cast wing installed behind and in line with the ripper cap Wings measure 6” or 8” from tip to tip and run at the same angle as the top of the ripper point Full-cast ripper points are best used in sandy soil conditions where high wear is expected These points provide long life and do an excellent job opening the soil and breaking the hard pan These points are not recommended for high impact areas Contact: FARM SHOW Followup R & H Machine Inc 115 Roedel Ave Caldwell ID 83605 toll free 1-800-321-6568 www rhmachine com

To read the rest of this story, download this issue below or click here to register with your account number.