Room For Welder Makes It Easier To Use Around Shop
 ✖  |
Adam Kool, Moravia, Iowa: "I made a boom for my Miller 250 welder that makes it a lot easier to use around the shop. The welder mounts on a rolling table with drawers to hold tools. I mounted the wire spool from the welder on the 6-ft. boom, which swivels 360? and is made out of 2-in. sq. tubing. It'll raise up over a 12 ft. high wagon or go down to 3 ft. high off the ground. I removed the wire feed mechanism from the side of the welder and mounted it on the end of the boom. The gas valve is also on the end of the boom."
Click here to download page story appeared in.
Click here to read entire issue
Room For Welder Makes It Easier To Use Around Shop WELDERS/TORCHES Welders/Torches 21-3-31 Adam Kool, Moravia, Iowa: "I made a boom for my Miller 250 welder that makes it a lot easier to use around the shop. The welder mounts on a rolling table with drawers to hold tools. I mounted the wire spool from the welder on the 6-ft. boom, which swivels 360? and is made out of 2-in. sq. tubing. It'll raise up over a 12 ft. high wagon or go down to 3 ft. high off the ground. I removed the wire feed mechanism from the side of the welder and mounted it on the end of the boom. The gas valve is also on the end of the boom."
To read the rest of this story, download this issue below or click
here to register with your account number.
