2015 - Volume #39, Issue #3, Page #41
[ Sample Stories From This Issue | List of All Stories In This Issue | Print this story
| Read this issue]
Seat Raised On Chevrolet Silverado
I made 12 risers out of 1-in. aluminum round stock – 6 risers for each seat. I tapped each riser on both ends at 8 mm. I installed 8 mm studs on top, screwed the new risers on existing studs on the bottom, and then used the factory 8 mm bolts that were on the bottom to fasten the seat in place on the risers. Now it’s a different truck! (Edwin Hankinson, 101 N. Hillview Dr., Georgetown, Texas 78628 ph 512 925-2548; ed.hankinson@gmail.com)
Click here to download page story appeared in.
Click here to read entire issue
To read the rest of this story, download this issue below or click here to register with your account number.